1.Mold surface must be thoroughly cleaned to remove all traces of wax, release agents, and other sealers.
2. Surface should be dry and free of contaminants.
3. Saturate a clean cotton cloth (not dripping) and wipe on a smooth continuous film. Apply no more than a few square feet at a time.
4. Wait 15-20 seconds. While film is still wet, wipe the surface with a second clean dry cotton cloth using a circular motion from the outside, working inwards until film is left dry and clear. See Notes below.
5. Repeat above procedures until entire mold surface has been covered.
6. Apply 4-5 coats, allowing 10 minutes between each coat.
7. Allow 20-30 minutes for full cure. Proceed with production.

Related Equipment